yes it does !! no problem !!!!!! your not  using a lot !!!!!!

I use a  graphite pencil  on the rails it works wonders!!!!!!!

try using graphite on the rails!!!!!

What size brass tube for 44 ton spilt axles??

Is this a duel motor or single motor??

This is what I was thinking,  was to try to glue the split axles ? I glad someone had success with it !!! I willing to try that !!! Dave it would be nice to see a pic of the inside of the chassie with the deocder in it ?? I wanted to put a soundtraxx decoder in it only if you could put a keep alive in it too !!!!

Honstly how many sets of do you think NWSL sells for that price ??

They are some pricey wheels more then I paid for the loco!!! to bad there is no other alternative

I have a 2nd generation 44 ton with  dcc  on board , the plastic on all the axles are split & they no longer make new wheels for it , Is  my only option to send it in to bachmann Nobody has this problem with there 44 ton ?

They really should make it easier to post pic's here!!!!!

Fix it with a #4 finish nail cut to size & a dab of hot glue to hold it in!!!!!

I went to run my SD40-2 the other day & it would not pull more then 1 car   so I looked at it & notice that the rear trucks were free spining , so I took it apart everything looked okay drive-shaft connected , took the truck out because it was still free spining open the worm gear up & found out the main gear is just laying in there ,the pin that holds it is gone !!!! can't find it  they don't sell the pin Any help !!!!

I e mailed the parts dept looking for windows for a GP38 model I own (they have a haze on it) they told me they don't have windows you you have to buy a shell !!!!!

It would be nice if someone would make a small keep alve for it !!!!!!

NCE makes a swap DCC board for this!!!!!!