Thanks for all the info guys, it helps to know this stuff before you buy!!!!
Hooked

Will a Bachmann 2-10-2 go thru an Atlas # 4 turn out without any problems?
Thanks

I have a Bachmann EZ Command controller with 2 Bachmann decoders and one Digitrax DH 123 decoder, that work great, my problem is with my new Digitrax DZ125 decoder.
It will not remember any address I tell it to, it will work great as long as I don't turn the power off.
As soon as I do that and then turn it back on the engine will not move, have to reassign the address again.
I took my engine HO 2-8-0 to my LHS where they have layout powered by NCE, everything worked great with the NCE controller.
Any ideas on what my problem might be?
Thanks

That is what I was doing (pressing both at the same time)
WORKS great now!!!!
Thanks for all the replies, Have a great day
Hooked

I have a new Bachmann EZ Command system, I have 2  Bachmann 2-8-0 engines with DCC on board.
I can't get the address to change from the default #3, Read the instructions over and over, looked at the forums, still won't work!!! Will take any suggestions.
Thanks in advance.