I'm workin' on an older single motor Hudson Williams Brass Engine #5405 that I found at a yard sale. The reverse board is an old one and I was wondering if I could replace it with the newer Williams 6amp  reverse board. If I can is there a wiring sheet on how to wire up the older motor to the newer board. The motor does run when I connect just to the motor.

Here are some pics of the older board. It did click a few times and then quit. I don't want to use this old one could be trouble down the pike..................

Quote from: DominicMazoch on March 04, 2009, 01:37:16 AM
Gee, what electrics are those??(Bad Pun)

Now, WBB is going to put CORRECT road numbers on GG's! 

BTW, do you run 4935 as a PRR or Amtrak unit?  Either is correct!

I run the 4935 as a PRR. From what I know any GG1 numbers that started with 48 were freight runners and numbers starting with 49 were for passenger runs.....................


hev

These are pics of my older Scale GG1's.  Trouble free since I bought them new. They see a lot of run time.....................















hev

How about changing the pressed steel handrails to wire handrails like on the older SD45's and the NW-2's.............................


hev