I have a TCS X1 sitting in my organiser that I could try to fit in place of the old one

Hi,
   Yes I have tried factory reset and no luck, the circuit board is the decoder :-(  thanks for looking and offering ideas cheers Jim

Hi there fellow model train enthustist,
I have an bachmann HO EMD sd40-2 DCC. I have had it for about six months now and it has been running great for about 4 months and then was packed up for 6 weeks and I unpacked it put it on my track and nothing so switched over to DC and runs fine but switch back to DCC and nothing so then go into the programming and check out it and then ended up reprogramming and still nothing and then tonight tried it again and reprogrammed it and now the rear light comes on no matter what direction it's on but nothing else works        Thanks in advance for any help. Cheers Jim

Thanks Rbryce1. Ok cool so I need to make my oval 4 foot wide to run them on happily, if I can work out how to put a pic up or a clip of my Berkshire running around my track I will thanks for the comments and advice very much lay appreciated chat again soon.      Jimmy

Hi Phil,
    Thanks for your reply  My curves make up just over a 3 foot circle  I have no idea what that works out in inches lol    I have a 2-8-4 Berkshire proto 2000 that runs around them no problem and have had a DD40AX run around as we'll with no dramas    Thanks cheers Jimmy

Hi I have just bought a 2-10-2 USRA light steam loco and it derails on my curves so am wondering what the minimum radius is required for this loco to run on? Thanks cheers Jimmy