I purchased this loco new on eBay, 11/22/2015. It came with the 16 Bit Sound-Traxx Tsunami sound module . I can operate it on DC no issues. I have an "MRC Sound Controller 2.0", that allows me to use a "Dual-Mode" feature, and access several brands of HO sound decoders (including MTH too!)
However, I tried setting (and restoring), the loco to "factory defaults" - but no success. I get Nothing in the Dual Mode (no run/no sound), & loco will not respond in the "Standard" setting; again no run/no sound...
It's the "Plug-and-Play" DCC "Sound-On-Board" exclusively made for the Bachmann EM-1
This Sound-Traxx Tsunami Decoder will only work (with no access to the bell, whistle, etc.), on straight DC...
What gives? Is it not for "Dual Mode?"
I do not have DCC on my layout...
Any help, for a solution, would be most appreciated...thanks!
Regards,
Captain Mudflap
However, I tried setting (and restoring), the loco to "factory defaults" - but no success. I get Nothing in the Dual Mode (no run/no sound), & loco will not respond in the "Standard" setting; again no run/no sound...
It's the "Plug-and-Play" DCC "Sound-On-Board" exclusively made for the Bachmann EM-1
This Sound-Traxx Tsunami Decoder will only work (with no access to the bell, whistle, etc.), on straight DC...
What gives? Is it not for "Dual Mode?"
I do not have DCC on my layout...
Any help, for a solution, would be most appreciated...thanks!
Regards,
Captain Mudflap