Where can I get car repaired and where can I buy a new one

Thank you

Can I hook up 2 number 4 switches together in order to connect two ovals of track and utilize my Bachman ez command system

Thank you.
How can I wire them together to the power pack

Just got first set with dcc ez command. Would like a simple layout that will allow me to get familiar with ez command. I have a lot of of track and 2 number 4 switches, and another dcc set.
Thank you for your time.

Thank you Len.

Thanx.
I have 2 trains, one that has 22 inch radius track and the other one has 18 inch.
In order to have 2 ovals, connect them with #6 turnouts and then can make spurs off of 18 inch for yards etc?
Thank you for your time and patience.

What is the difference between these 2 switches.

Easiest way to connect 2 ovals. I have 2 number 4 switches for my Acela .the other set is 18 inch radius.
Want to run them off my Bachman ez command system
Thank you

I have the Acela Express dcc and echo valley express dcc with ez command controller.
Want to run both trains together and set up some spurs for freight train.
Looking for a not to complicated layout. I have lots of track and 2 number 4 remote switches.
Thought first problem was to hook up both trains to controller.
Thank you in advance for your time.

Just got a Bachman set with ez command. Have 2 trains I want to run. Are there any retailers that have 2 inputs 2 inputs so I can input to ez controller. If not, what do you suggest.
Thank you.

What would you suggest in place of the number 6 crossovers?
Multiple number 4 or 5 switches
.thanx!

Which switch should i use to connect two ovals of track. Will either be two 22inch track ovals or a 22 and 18.
Want to run two trains at the same time.
Thank  you/

Thanx again. I assume it would be ok if i keep that part of my layout separate and only run my new freight train, that came with 18 inch radius curved track, separate.
Also if you don't mind another question,,,,on the Bachman dcc controller, can i only set up one loco at a time on the track?

Should I then get 2 number 4 switches and substitute 22 radius curves for the inner loop.
I assume my passenger train would not run well on 18 radius curve? The passenger set train came with 22 radius curves.
Thank you.