I am looking for any videos or help topics explaining the magnetic uncouplers that are placed under the EZ track and also any relevant info for using the magnetic couplers.

I have model 44875 E-Z #6 n scale cross over. I have lost the package with the wiring diagram. Is this available?

Looking for someone in area code 23464 who does train repairs and installs for sound decoders.

Ok, good reply. This clears up much. From the previous reply it sounds like the recommended decoders are really a "plug and play" because they have a speaker. Is this correct? I see that the recommended decoders have a few choices. Is one a base line so to speak or will all work for my situation I have described? Thanks for the feed back. Good forum.

I'm more than a little confused here. I purchased this engine as "DCC" equipped and now I have to replace the decoder? OK, there are so many accessories for this subject matter that it gets a little more confusing trying to figure it out. After replacing the decoder what else is needed? I am using the stock controller #44212 which is stated as DCC compatible.

I have GP7 DIESEL LOCO (DCC) D&RGW #5102. I would like to start learning and working the DCC "sounds". What are the minimum parts and/or accessories I need to start the sound function? I am currently using the EZ track system. Also, if I run more than one of the same engine will the sounds still activate?
Thanks, good forum.

I was thinking more about the street cars and trollies i.e. Brill Trolley and Peter Witt streetcars, etc. are these the correct compatibility?

I recently purchased the auto reverse set and I see there is no rolling stock. Is there any particular type that I need for this system?

Is it possible to run item #44876 & item #44875 in line so as to create a double crossover? I have tried but I cannot isolate the inside and outside to run on two separate transformers. KATO has item #20210 that is one piece for a double crossover.