thanks for advice. Will look and see.

Hi out there,

I have installed my first SDH164D sound decoder in my "Connie".
I am struggling to synchronize the chuff rate. The factory setting is way out of sync.
Anyone had experience with setting this particular decoder?
The manual talks of adjusting CV 133 and 134 according to wheel diameter. Would be great if I could get hold of settings?

Help!

Thanks Tom. I guess I should go for the quality hey.
Regards

Anyone had experience with the following decoders? Are they any good?

DSD-090-LC or DSD-B280LC.
Wanting to put into my 2-8-0.

Thanks guys. All sorted.Blower sound is back!!

One more thing.
I notice on the decoder specs sheet for this loco that they list a speed table within the range of values CV67-94. I had a look at this and made some adjustments.
I have put a good slow speed on the loco, really sounds great.
However now the chuff rate is quite a bit out of sync? The default value is on 39.
Is there perhaps a speed vs chuff rate value table that can help with synchronizing of the chuff rate and speed?  Or is it a matter of trial and error?

Hope this makes sense.

Thanks very much. Will try do.

Hi guys,
I recently purchased the 2-6-0. My first sound equipped loco. Great for me. However I have lost the "blower" sound. Whistle, bell, compressor sounds there, but some how lost blower?
I use the NCE DCC. It was working fine when pressing 4 on power cab.
I tried to reprogram using the dcc fact sheet for the loco but no luck.
Should I try a factory reset? If so how?
Help please!!!


Bogey