Perfect! 
- Welcome to Bachmann Online Forum.
News:
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
HO / Re: GE 70 ton locos with DCC
May 23, 2016, 10:46:00 PM
Thanks for info.
They are now both running on address 3. However now I cannot change any of the CVs or the addresses on either loco. I use a Digitrax Zephyr and a DT402D controller and both Page and Ops Mode programming.
They are now both running on address 3. However now I cannot change any of the CVs or the addresses on either loco. I use a Digitrax Zephyr and a DT402D controller and both Page and Ops Mode programming.
#3
HO / GE 70 ton locos with DCC
May 23, 2016, 09:26:04 PM
I have recently obtained two GE 70 tonners. They have "DCC on board" printed on the fuel tank but will only run in DC mode. How do I enable the DCC mode? I am keen to get these sweet little locos up and running. 
Pages1