News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - DukeBoyty

#1
Hello i lost my Manuel for my train and i needed the cv codes so i was wondering if anybody could send me them or a site with them on it THX!
#2
Quote from: Hunt on May 01, 2016, 01:56:31 PM
DukeBoyty, What DCC system are you using?




Resetting the sound decoder CVs to their factory default value is a two-step procedure.

  1)  Program CV 8 with 8 (can use either Service Mode or Operations Mode programming)
  2)  Cycle power to the decoder by turning power to the track off and back on

After about six-seconds upon restoring power the headlight and backup light will blink simultaneously 16 times indicating that the CVs were successfully reset. However, if sound or lights come on immediately upon restoring power, the decoder did not successfully reset. Repeat the two-step procedure.




Click Here for  the Bachmann HO 2-6-0 Sound Value decoder supported CVs and their default value.  Currently there are some discrepancies between the document and the decoder.  Use the CV default value read from the decoder to correct the file.




Thank You!! Resetting the loco worked i didn't think that it was the same as my GP 35 Diesel Locomotive To Reset it, I am using the Digatrax DCS-100 5-Amp.
#3
Hello, I Just bought a bachmann HO Alco 2-6-0 steam loco sound equipped and it is accelerating WAYYY to fast and slowing down WAYYY too slow I was gonna reset it to factory defaults but i can't because i don't know the cv number and value to do it, also if that doesn't work i don't know what to do after that, i also have a Bachmann Diesel loco and it accelerates and slows down just right, for the steam engine if i turn the knob on the remote (plugged in or not) its like it is on full then it takes about 10-20 seconds to slow down.