I have a Bachmann Santa Fe 4 8 4  steamer that is no longer running properly.  If I send it in for $25 for a replacement, what loco is Bachmann providing in return?

Thanks, meant EZ Command.

Is the installation of a dcc decoder in the HO Acela Express :loco plug and play?  What decoder would you recommend?

Does either the Dynamis or the EZ Command  dcc controller support running one non dc loco?

I have the acela set not the hhp.

How difficult is it to add a dcc decoder to the acela express loco?  Is it as simple as plug play?  What decoder would you recommend?

Is it easier to convert to dcc?

Can both Dynamis Track Outputs be used at the same time so that I can connect the plug to my Bachmann track and the other connection to my Kato track?

What is the advantage of the new motor?

I'm trying to change my Bachmann loco address from 3 to 4 on the main track.  I can go through the complete process which shows the program track icon above the menu key and then click the menu key, but the loco doesn't change addresses.  Any ideas?

I'very figured it out.  Thanks.

I just got the Bachmann Dynamis.  I've read the booklet, but what key do I have to push to get the menus to appear so that I  can change the timeout?

I have the bachmann ho acela dcc ready set that I currently run on dc.  What do I need to purchase to convert and run on dcc?

Is the n scale white christmas set bac24016 or the locomotive for that set still available?

It's funny I have seen reviews of the set that say there is a problem with derailment unless you have a large layout.  I have a relatively small layout 304 and have no derailments using Kato track and the two engines with power car.  Perhaps adding cars increases the possibility of derailments.