Thanks a lot RR you've been a great help.

Cheers.
Dave

Thanks RR for that info.
I will be using the EZ Command Control as a matter of fact so are those
simpler decoders you mentioned still available,

Dave

Thank you gentlemen, appreciate the quick answers.
I'm new to the DCC game and learning.
Is there another type I can use here ?
Am I correct in assuming you can use them on any make Loco.

Dave

I would like to get decoders for a couple of DCC ready engines I have.
I was thinking of the Bachmann # 44916. EZ decoder.
Does that sound OK.

Dave

Yeah, that's about it.
Note, you don't have to remove the couplers so that makes it a little easier.
So this Diesel has the full decoder board installed, I was hoping it would have
the plug in decoder as I need to get some for a couple of DCC ready engines I have.
I was thinking of the Bachmann # 44916. EZ decoder.
Does that sound OK.

Dave.

Thanks a lot guys for your help.
I already had the tank off and it shows two screws.
I wasn't sure if something would fall off inside if I loosened them.
Sure wish the manufacturers would add this info. on the sheet.
Cheers.
Dave

Are you sure you're looking at the right diagram ?
I can't see any 4 screws.

Hi all ...Just bought myself a new SD40-2 Diesel and was trying to figure out how to remove the shell without damaging same.
Anyone !
thanks.