Quote from: ACY on October 03, 2014, 01:30:18 AM
It sounds like you may have inadvertently created a reversing section/loop which requires the use of a automatic reversing module or special wiring including isolating the reversing section.  This is most likely the issue and is causing a short circuit.

I think this is what I did. It was basically a figure-eight with some of the sides extended a bit.

Hello everyone,

I bought the Bachmann starter set. It's the DCC set that comes with two locos and some track. I also bought a Bachmann track set, since I wanted something more than just a simple loop. My issue is that when I try to expand the track layout beyond a simple loop, the EZ Command will just flash the Stop and 1 light very fast. When I go back to the one loop, it works fine. Are there limits to the track layout with the EZ command?

Thanks.