Dear Rich G and Hunt, reset the CV 29 values and all is go 
Many Thanks for your help
Fred

Dear Rich G and Hunt, many thanks for your replies, The one done with the Dynamis will be safe to try, I've left them on the shelf, the one programmed with the Prodigy needs sorting out, I'll borrow it and try and read CV 29 and enable DC and DCC - sound confident ?  I haven't got an idea but for the help here and on forums

Many Thanks,

Fred

I am tempted to do an HO run, just seen a Birney with DCC on board, and a Peter Witt with same specs - if only I had expandable space 

Thanks for your reply, if i leave it to run DCC and DC as I could then use it on both layouts - will it cause problems i.e. motor burn out or anything else?
Many Thanks,
Fred

Hello, I am new to this site but need help if possible, I bought an N Gauge Peter Witt Street Car with 'DCC on Board' ran on DC perfectly, was lent a Gaugemaster Prodigy Express DCC I believe it is sold under a different name in U.S. any way it ran well on DCC but now will NOT run on DC, I only gave it an address 4 figure and as far as I know change nothing else - can some one please tell me what to do? the strange thing is I programmed another Peter Witt but this time with a Bachmann Dynamis DCC set up and that Street Car runs on both systems, any help would be really appreciated, I am a total newbie to DCC, and long in the tooth 
Thank you in advance for any help you can give me

Fred