Quote from: Trainman203 on July 02, 2020, 04:11:30 PM
Scratchbuild one?

I did consider that but not sure I have skills or the eye sight!

Need help with my Sound DD40.

It is missing the left side cab door and Bachmann will not sent me a spear door but say i must buy a complete shell.

Hoe can I fix this problem?

I live near Oxford UK.

Thanks Hunt I will give that a try.

The loco dose stall on points when using the Zephyr but it dose not when using the EZ Command.
I know the EZ puts out more track voltage than the Digitrax. Maybe the Tsunami needs that extra boost.

Quote from: bapguy on December 19, 2013, 09:43:07 AM

Cut and paste this  http://www.digitrax.com/tsd/KB33/programming-soundtraxx-tsunami-decoders-with-digit/
It tells how to program Soundtraxx decoders with your Zypher.  Or try a 1K Ohm resister across the programming track. Reset the decoder to factory settings CV8= 8. This will set the decoder to address 3 Joe

Thanks Joe.

I did try that but did not work. But I was able to reset the address using my EZ Command so the loco now runs but keeps cutting out

John.

I Got a very nice Bachmann 4-4-0 Richmond with factory fitted sound.

I got the loco very cheap $50 plus shipping to UK because it is/was a non runner.
When the loco is put on the track I get the stem hiss/pumping sound of  the air pump. I do not know the loco address.

The fault is the decoder.

I put in a blanking plug and the loco run very nicely on DC. I then put in a standard Bachmann decoder and again the loco ran very nicely.

My Digitrax Zephyr can not detect/read the decoder.