News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - locobill

#1
On30 / Re: Baldwin 4-6-0 decoder needed No sound
May 08, 2019, 06:42:39 PM
Ton, Thanks for responding. Excuse my ignorance, but what is back EMF?
#2
On30 / Baldwin 4-6-0 decoder needed No sound
May 08, 2019, 12:20:04 PM
I have a Baldwin 4-6-0 that currently runs DC only. What type of non-sound decoder would be easiest to install?
Bill
#3
On30 / Re: REPLACEMENT GEARS
December 16, 2013, 05:42:06 PM
I received my gears this past week. Using the instructions and pictures provided by Larry, I was able to get the trucks disassembled BUT can not get the clips off the drive shaft. I know where the clips should be, but do not see any place to press on the clip ends. I have looked through a magnifying glass and can not see the clip ends on the inside of the axle.
Has anyone else run into this problem?
I guess the only thing left to do is to send the loco into Bachmann and have them replace them.
Bill
#4
On30 / Re: Problem replacing the gears
December 09, 2013, 06:21:41 PM
I tried sending a couple small pictures, but it said the upload folder is full!?
#5
On30 / Problem replacing the gears
December 09, 2013, 06:20:57 PM
I am replacing the drive shaft on my Shay and have run into an issue.
I followed the pictoral on the Railroad Line Forums showing how to release the clips.  On the
back side of the clips, I only see two holes with no prongs to press in to release the clip. I have pushed
into the holes with no luck of releasing anything.
Has anyone run into this issue? Any suggestions? 
THanks,
Bill
#6
On30 / 4-6-0 won't run
November 14, 2013, 03:47:43 PM
I just received a brand new On30 4-6-0 from a dealer on Ebay today. The lights and sound works fine when I use Channel 03, but no movement at all!  I have a Digitrax DCC system and other locos run fine.
Anyone have this problem? Any thoughts on what to do before I send it back?

Bill