Yep' site was down yesterday ,they were working on the server,
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: SteamGene on December 19, 2007, 12:35:17 PMin the case of small brass tubing ,find a small thin brass washer and solder it leaving 1/4'' to be inserted into the tender body.This will give a great deal more support.
Barry,
Do you have some pieces of round brass or copper wire that is about the same thickness as the pin? If so, I'd cut the rest of the pin flush with the tender body, sand as necessary, then drill a hole of the correct diameter and fasten the new metal pin to the tender using CA. Plastic tubing or stock might do as well.
Gene