Does anyone have knowledge of decals that are for harbors?  I have a water scene that has its own switchers.  I am hoping to find decals that said "Harbor", "Seaside", or even "Piers"; but cannot find them in HO scale.

I have tried Micsoscale, and walthers, to no avail..

hotrainlover

I had a problem like that with one of my 4-8-4's.  I glued a washer to the top of the truck, after I reemed out the hole for the screw shaft.  I then painted the washer and weathered it.  I have to point it out for others to see...

I have not had any problems since.

hotrainlover

Mr. Bachmann,
Is there a recommended limit to how many decoders can run on the basic Bachmann DCC system?  Also, how many for the new 5 Amp system?
Thanks,
hotrainlover

Trainbrain,
Who or what is "FTD"?

Hotrainlover

I model the GN.  The one from Percision Craft seens too expensive!!  I really want this engine...   But I cannot afford $400.00.  I WILLNOT pay Brass prices for plastic.

hotrainlover

Gus,
Could you caotact me at my email addy?  I would like to find out about this product...
Thanks,
hotrainlover

I really liked your work.  Where did you get the tanks from....
I like the whole theme!

hotrainlover

Dear All,
What is required to put a decoder in this Loco?
Is the motor "Isolated"?
Can anyone send me the original drawings?
Contact me at my email, if needed.  If anyone has pictures..  That would be GREAT!!
Thanks for the help.

Hotrainlover

I use my FEF-3 to do "yard" work, that has many 18" radius curves.....
This is the latest 4-84 that Rivarossi produced; tho....
Lee

Nigel,
I just want to be able to turn lights (fore and aft), on/off.  Control speed and change directions.  Is there a particular # of functions "required" to do this?  Do you need 2 functions to turn lights on AND off?(for example?)  Or does it need to just one per operation?  Would I need only a 4 function decoder, or 6 to do this?  I will not be adding sound anytime soon....or never

Ivarass,
Do you have pictures of what you did for sound?  Please contact me off-forum if you can on how you installed this  

Thanks again, for the help!

Yes.  I do it all the time

Dear All,
Has anyone put a decoder in this engine?  It has a 8 pin connector.  Is there any decoders to NOT use?  I use the Bachmann EZ-Dcc system.  If that matters...  or not

Thanks for the info....

Lee

BaltoOhioRRFan,
Thanks I JUSTFound it!!  You, just when you thought you looked......everywhere.....

Mr. Bachmann,
I am confused...
I was under the impression that Bacmann receilently came out with a "New" 4-4-0?  All that I can find are pictures of "Standard" line 4-4-0's.....
Please help!!

Thanks in advance!!

hotrainlover

Stephen,
While you are at WallyWorld...  Look in the same area.  There are now MANY 1/87 scale models in diecast.  I just picked up Vans($1) in the clearance isles.  There are a lot of cars there also.  Especially the 1950-1570 range.  It is hard to find Transition area vehicles at &1.98....  ANYWHERE else...

There is also a good selection of  1/87 race car models.

Lee