I have not had issues with them, but yes, they're somewhat difficult to replaced because you have to remove the side rods from the drivers to replace them.
Please read the Forum Code of Conduct >>Click Here <<
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: Maletrain on January 28, 2015, 08:59:38 AMIf you get a DCC ready Spectrum Short tender, then it's a direct swap. Just take out the screws to the rear truck and the two smaller ones in the front, take off the shell, unplug the DCC plug harness from the locomotive, take off the tender drawbar, and then swap out for the new short tender.
As many of you have noted, the "medium USRA" tender that comes standard on the 4-6-0 seems too large. I have one of the "short USRA" tenders that I want to use, instead. My 4-6-0 is DCC, so I am wondering how much work is involved with swapping the tenders. Can I simply move the decoder from one to the other without rewiring? Does it even fit the smaller tender?