Is there any way to reset a decoder (Digitrax DZ123) in
a loco? It stopped running last week and I was able
to reprogram it to a new address. It runs fine in reverse
but lurches forward in the forward direction. I can turn lights
on/off. I would like to just try doing a reset (using CV8)
to factory settings but it doesn't look like I can do that
with E-Z Command.
thanks for any help.
a loco? It stopped running last week and I was able
to reprogram it to a new address. It runs fine in reverse
but lurches forward in the forward direction. I can turn lights
on/off. I would like to just try doing a reset (using CV8)
to factory settings but it doesn't look like I can do that
with E-Z Command.
thanks for any help.