Hi out there,

I have installed my first SDH164D sound decoder in my "Connie".
I am struggling to synchronize the chuff rate. The factory setting is way out of sync.
Anyone had experience with setting this particular decoder?
The manual talks of adjusting CV 133 and 134 according to wheel diameter. Would be great if I could get hold of settings?

Help!

Anyone had experience with the following decoders? Are they any good?

DSD-090-LC or DSD-B280LC.
Wanting to put into my 2-8-0.

Hi guys,
I recently purchased the 2-6-0. My first sound equipped loco. Great for me. However I have lost the "blower" sound. Whistle, bell, compressor sounds there, but some how lost blower?
I use the NCE DCC. It was working fine when pressing 4 on power cab.
I tried to reprogram using the dcc fact sheet for the loco but no luck.
Should I try a factory reset? If so how?
Help please!!!


Bogey