News:

Please read the Forum Code of Conduct   >>Click Here <<

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - mfarns

#1
General Discussion / Re: Making a track power wire (DCC)
December 25, 2015, 09:59:14 AM
Outstanding, thanks! (and merry Christmas)
#2
General Discussion / Making a track power wire (DCC)
December 24, 2015, 09:24:24 PM
My grandsons lost the track power wire for their ez command system. I have some wires intended for the dc connections from the ez track system that have spade connectors on them. I got a 3.5 mm plug from radio shack and thought I would just make a new one. Can someone tell me which leads of the plug I should solder the wires to? I know the tip (left channel) goes to the small lead, the center ring (right channel) goes to the medium lead and the shank (ground) goes to the large lead. Which two should the track power wires connect to? I thought about plugging in the jack and checking the leads out with a voltage tester but not sure how to interpret the results. I'm an extreme novice when it comes to the electrical side.