Hi
I have this trolley see photo and have no papers at all. What is the part # for the trolley and where can I find a exploded drawing of it. I have pulled it apart and can not figure out the polarity of the plug 8 pin inline plug that goes between the motor and up to the pcb on top. Should have taken a photo before taking apart! duh. I have yet to run it. Will the dcc address be #3 ? Using E-Z controller.
Thanks
Charles in NZBachmann.jpgBachmann.jpgBachmann.jpg
It would seem You have more than one issue...
The EZ Command won't "read or set" the DCC address
The picture You did not take would be very helpful
My advice would be to seek the help of a local club that runs DCC or has a member willing to assist
Thanks JonJet for message. Mainly the drawing I want. Why does EZ not work. There is a decoder in this model. See photos.
Thanks
Charles
Drawing is in the parts and service section under HO/Streetcars and gas electrics/Peter Witt
https://shop.bachmanntrains.com/documents/84601.pdf
Hi jward
Thanks for the link. Magic.
Charles