Hi, I just bought a HO E7. I have Digitrax for DCC. I dont have a programing track. I want to change the address from 03 to 04. Any help appreciated.
Thanks, John
Since this is a Bachmann forum, all I can suggest is to program on the main.
I have done it with my NCE system once I did the initial program track stuff if I wanted a new engine number. Just no other loco on the main. Your manual will give you instructions.
Here is a good Good Group for Digitrax users.
https://groups.io/g/Digitrax-Users
Rich
Digitrax systems have trouble reading Lenz type decoders like Bachmann. The solution is simple. Set yourself up a programming track using a couple of sections of track connected to the programming leads of your command station. Then, you connect a 1000 ohm resistor across the rails of the programming track. I modified my resistor by soldering alligator clips to the ends of the leads so that i could remove it when not needed.
With this setup you should be able to reprogram the decoder according to your user manual. What system are you using?