Print Page - How to set DCC turnout default position with dynamis control?

Title: How to set DCC turnout default position with dynamis control?
Post by: HawaiiTbird on November 03, 2013, 04:44:52 AM

newbie to the forum!! I've looked everywhere on the web and tried to look on this forum for an answer -- cannot find how to tell turnout to change its default power-on position. Any help greatly appreciated. Would also like to know if there is a more advance manual that has this kind of answer for DCC Dynamis users.

Title: Re: How to set DCC turnout default position with dynamis control?
Post by: richg on November 03, 2013, 08:21:03 PM

Here is the manual which is in the Bachmann site. The Dynamis manual is there also.

http://www.bachmanntrains.com/home-usa/ez_content/EZ_Command_DCC_Turnout_Instructions.pdf

Rich

Title: Re: How to set DCC turnout default position with dynamis control?
Post by: HawaiiTbird on November 04, 2013, 01:55:04 AM

I've already looked at the new DCC Turnout manual. It shows how to set the Turnout address, but not how to set the turnout default position. Stll hoping for an answer.

Title: Re: How to set DCC turnout default position with dynamis control?
Post by: Jerrys HO on November 04, 2013, 06:42:26 AM

The link Rich provided shows how to set the default position also. Page 2 has it there.

Jerry

Bachmann Online Forum

Discussion Boards => General Discussion => Topic started by: HawaiiTbird on November 03, 2013, 04:44:52 AM