Hello all; I've heard that there are schematics over here at Bachmann that detail how to connect some of the different DCC decoders from aftermarket suppliers. Is this true? If so, is there a schematic that shows how to connect the Airwire 900 G3 decoder to the Bachmann K 27 board in the tender? Any help would be 'hot'. Thanks in advance, Jeff
Quote from: Jeff Winthers on February 03, 2013, 07:13:43 PM
Hello all; I've heard that there are schematics over here at Bachmann that detail how to connect some of the different DCC decoders from aftermarket suppliers. Is this true? If so, is there a schematic that shows how to connect the Airwire 900 G3 decoder to the Bachmann K 27 board in the tender? Any help would be 'hot'. Thanks in advance, Jeff
There are no schematics that I know of, just some messages by users on different DCC companies.
Just follow the NMRA standard for DCC and the decoder instructions will show about the same.
I just did a search for Airwire 900 G3 decoder
They follow NMRA standards.
Rich
My bad. I forgot to search the Bachmann forums. It was right there all along.
Rich