Discussion Boards => General Discussion => Topic started by: phranklyn on September 16, 2011, 07:21:03 AM
Title: ez command turnouts with nce powercab
Post by: phranklyn on September 16, 2011, 07:21:03 AM
I asked this previously. I did not save or write down the answer. How do you program EZ command turnouts using a NCE powercab system? Thank you for any help.
Title: Re: ez command turnouts with nce powercab
Post by: richg on September 16, 2011, 09:06:36 AM
What does the manual for the Power Cab tell you about programming an accessory decoder?