E-Z Command Decoder: Setting Address using Digitrax Zephyr

[peteajr]

Just purchased and installed an E-Z Command decoder (item 44915) but am unable to change the address from the default 03.  Followed instructions in Zephyr manual but it just will not write a new address.
Any advice, insight?
Thanks

[Hunt]

Workaround required for CV read and programming a non-sound Bachmann decoder using a Digitrax Zephyr.

Workaround --- Place a 1000 Ohm, ¼ Watt resistor across the programming track. Remove the resistor after you finish programming the Bachmann decoder.

[peteajr]

Thanks!  I'll give it a try