Broken tender pin

[BIG BEAR]

     Hey All,
    I have a On30 mogul running around my christmas tree this year. Now just the engine, as I have broken off the link pin on the Tender.
    Does anyone have a good fix for this? As I don't think model glue or others would hold up to the strain of pulling a few cars around.
     I'm sure others have done this , if you would please let me kwow how you handled it.

        Thanks,
                Barry

[SteamGene]

Barry,
Do you have some pieces of round brass or copper wire that is about the same thickness as the pin?  If so, I'd cut the rest of the pin flush with the tender body, sand as necessary, then drill a hole of the correct diameter and fasten the new metal pin to the tender using CA.  Plastic tubing or stock might do as well.
Gene

[Dusten Barefoot]

Or, fi you still have the pin, super glue it back in the place that it broke. I have done this to my mogul and it still holds.
Rock On & Live Strong
Dusten Blake Barefoot

[GN.2-6-8-0]

Barry,
Do you have some pieces of round brass or copper wire that is about the same thickness as the pin?  If so, I'd cut the rest of the pin flush with the tender body, sand as necessary, then drill a hole of the correct diameter and fasten the new metal pin to the tender using CA.  Plastic tubing or stock might do as well.
Gene

in the case of small brass tubing ,find a small thin brass washer and solder it leaving 1/4'' to be inserted into the tender body.This will give a great deal more support.

[Woody Elmore]

Try the old HO Brass remedy - use a long 2-56 screw with a nut on it. You may have to drill a hole for the screw. The nut goes on under the draw bar and helps keep the engine and tender coupled. If you want you can also use a piece of brass tubing around the screw - it looks a little nicer.

[BIG BEAR]

   
      Thanks all for the help!
    I took ideas from these. I used a galvanized nail, ground the point off,(too proper length), drilled a hole in the tender, glued it in place, & finally painted it flat black. I need to test run later today.
    The first nail I used, I cut that sucker twice & it was still too short.

         Barry