Replacement Parts

[KB5JCX]

I have an Atlas RS=1, product number8106.  Thirty years ago, it was dropped and broken in a high school science project and I am just now getting around to fixing it for my layout, now I am finally retired.  One of the trucks is broken.  I cannot find any spares from Atlas.  Does Bachmann make a truck that will fit it?  Thanks - Ross

[WoundedBear]

The chance of a Bachmann drive truck fitting an Atlas model is slim to none, in my opinion. Go buy a new locomotive.......you will be much happier in the end.

Sid

[rich1998]

I have an Atlas RS=1, product number8106.  Thirty years ago, it was dropped and broken in a high school science project and I am just now getting around to fixing it for my layout, now I am finally retired.  One of the trucks is broken.  I cannot find any spares from Atlas.  Does Bachmann make a truck that will fit it?  Thanks - Ross

If you really insist on repairing your loco, try the below link.

https://shop.atlasrr.com/c-1070-ho-locomotive-spare-parts.aspx

I have seen the Atlas RS-1 on ebay also.

Rich

[jward]

The Atlas RS1 should use the same truck as the RS3. Try looking for the parts you need under that locomotive at the link Rich provided. There are enough parts listed that you should be able to assemble a complete truck from them.

[KB5JCX]

Thanks - I ordered the parts and a couple of others just in case I broke one.  This engine has sentimental value to me and, as a retired Texas teacher, I cannot afford a new one - I am stuck with DC because I do not have $1,500 plus to convert everything.  Thanks though.  RL

[KB5JCX]

Trucks fit except that the gear case is about 5 mm too far away from the fly-wheel for the spin shaft to fit (spin shaft connected between fly-wheel and worm gear).  So, I used the old gear box frame with all original stuff except the side-mounted wheel covers.  I had a broken "snap" fitting on gear box, so held that side with a zip tie.  It held fast so far and the RS-1 runs well on the straight-and-level forward and back.  I will let you know about the rest of the operation as soon as I get the track back up.   I am doing some track lay-out modification and rewiring.  It should be ready in less than a week.  Thanks for the help you guys.  I appreciate you all trying to get me to buy new, but some things have so much sentimental value and I do like to solve problems.  It must be the "engineer" in me - laughs.  RL

[KB5JCX]

My repair job with the zip tie works like a champ!  The RS-1 is a great workhorse and pulls about 23 cars at a time.  It would pull more if not for the two curves and uphill 1% grade.

[jward]

I don't have an RS1 but i do have an S2 which had a similar cast metal chassis. It will pull double what the Bachmann S2/S4 will pull. Those were some well built, durable locomotives. Glad you got yours running again.

[JLK2707]

Good for you!:)