PC Board wire up for the E60 Electic Loco

[[email protected]]

Hi There,

Does anyone know how to wire up the PCB Board for the E60 Electric loco? There are a '+' and '-' terminals marked on the board, so assume this is where the power input from the truck pickups goes. Does the motor need to be connected to these also or is the PCB Board for sound and LED's only? In other words is the motor independent of the PCB board?

Any help would be greatly appreciated.

Thanks

[brokenrail]

I believe this board is similar to the dash 8 and a good magnifier will show what goes where .They are labeled for motor,pickups at the front and rear of the board.LED #1 ,2 and 3.If this is a dcc ready circuit board with the plug.
Johnny