auto reverse track and DCC

[billgiannelli]

I see Bachmann offers an auto reversing track. How might this work with DCC(ie dynamis) ?
Considering a Bachmann DCC trolley....
Thanks
Bill

[billgiannelli]

.....or would an auto reversing module be used with DCC?
Thanks
Bill

[Flare]

Bachmann auto-reversing track has additional wiring underneath it that is designed for use with an auto-reversing controller included with auto-reversing starter sets (which use DC, not DCC) to power trolleys and locomotives.  Bachmann also uses Dual-Mode DCC modules that are compatible with DC operations.


The 'DCC Reverse loop module' is designed to allow a DCC-controlled train to travel through a loopback track without shorting out.  It is not meant for end-to end operation.

[billgiannelli]

Thanks for your answer!
Is a reverse loop module the same as a "auto reversing" module?
I understand what a reverse loop is. But i am talking about only auto reversing.
thanks
Bill

[Hunt]

The Bachmann Automatic Reverse Loop Module is used to switch the rail polarity where the track loops back on itself. It works with DCC only.

[billgiannelli]

perhaps there is a little confusion here.....
I am not talking at all about The Bachmann Automatic Reverse Loop Module.

[Hunt]

Bachmann auto-reversing track does not work with any DCC system. This track requires the reversing electronics available only with one of Bachmann auto-reversing sets.

[billgiannelli]

thank you for your answer!
So how would I do auto reversing with DCC and "standard" track?
I see other companies sell "auto reversing" modules. (NOT reverse loop)
Thanks
Bill

[Flare]

You don't HAVE to use DCC control for Bachmann's DCC-equipped trolleys/locomotives.  The decoders automatically switch to 'analog mode' when controlled by DC controllers like the ones included with auto-reverse sets.

[Hunt]

Flare,
I have not tried it, so do not know how well a dual mode DCC decoder will work with the Bachmann special wired track auto-reversing set.



Bill,
Most commonly found electronics to automatically run a train back and forth using standard track works only with DC. There are a few that will work with DCC. 

Click Here for one that is made to work with DCC.

[billgiannelli]

Hello all!
Thank you for all your help and information!
Bill