Allocating Hot Keys using EZ Dynamis and Cobalt ADS-2fx

[DrJay]

I have successfully programmed a Cobalt ADS-2fx to switch two pairs of points. I have tried to assign Hot Keys to both units but nothing seems to work. I am using a basic Dynamis Command and Control unit (no probox) and have followed the instructions to the letter in the user guide but to no avail. I have assumed rightly or wrongly that by pressing the appropriate hot key, say F1 that it would take me to the accessory address that I have allocated to that F key. The manual also suggests that you press shift F key. If I do that I get F11. does this mean that in fact there are 20 hot keys within the unit. Any help in solving this Hot Key problem would be much appreciated. DrJay

[Hunt]

Make sure Dynamis is in accessory mode.

[DrJay]

Many thanks for your reply. I think I've cracked it. DrJay