EZ track dcc turnouts

[rjwalter]

Can Bachmann's EZ DCC track turnouts be programed and used with NCE or MRC's Dcc systems?
If so both types of connections?....directly connect via a wire or wireless?

[Hunt]

Following  NCE instructions  --  MRC similar


Do not place the NCE in any programming mode. Thus you will not be using the NCE Program Accessory Decoders (Shortcut = PROG 7) procedure.

1) Locate and remove the turnout's programming button cover (see the instructions that came with the Bachmann turnout).

2) Using blunt end instrument (such as a ballpoint pen), press and hold down the program button on the turnout to be programmed until the turnout rails stop toggling. Release the programming button.

3) On the NCE Cab (throttle), press SELECT ACCY key. Key in the address to be assigned the turnout followed by pressing the ENTER key.

4) The rails of the turnout will toggle to indicate it has accepted the address and exited the programming mode. Carefully replace the turnout's programming button cover