dynamis probox set up help.

[raptor106]

hi
OK so i finally got my dynamis probox up and running and i did what the manual says to set up both maintrack and service track. i set up service track by isolating rails from rest of the layout with insulating rail joiners on both rails.
then added separate power with terminal/rerailer track in that service track area. then i hook up wires to the dynamis command station output.
for main track i hook up wires to the dynamis probox output. now i put two locomotives on layout, one on main track and other on service track and when i program one engine on service track it program both engines to to same number. did i miss something? 

[captain1313]

Raptor,
Where are you pulling the power for the service track from?  When the base and pro box are connected there is a port for the wires for the program track.  When not programing it feeds the same power as the main track.

Kevin

[raptor106]

ah ok. i'm guessing dynamis system can only do one service track. cause on my layout i have 2 siding that i turn in to service tracks by hooking wire together to link up to dynamis command center. so if i have two engines on each service track they be program together unless one on main line.

[richd286]

The isolated service track should only have one loco during programming.  Also, make sure the loco/tender wheels have not crossed the insulated joiners and connected to the track beyond,  the entire system becomes a service track and takes the instruction.   I won't let that happen again!!