DD40AX for DC operation

[JNXT 7707]

I have a new Bachmann DD40AX "DCC on board" on its way, and wondering if I can put it on my DC layout immediately or if it requires making an adjustment to the decoder?
It is advertised as dual mode, but not being DCC-savvy not sure what is entailed.
Thanks

[jward]

the short answer is yes it will run on dc. but since the decoder will use up about 5 or 6 volts of your track power you will find the loco's performance sluggish. look for a dummy plug in the box, open up the loco, unplug the decoder and use the dummy plug in the socket. this will restore full dc performance.

[JNXT 7707]

Thanks! That's just the info I was looking for.

[richg]

Below is the diagram you got with your loco. It has the instructions.

http://www.hoseeker.net/assemblyexplosionbachmann/bachmannspectrumdd40axdccpg2.jpg

Rich

[JNXT 7707]

That's a big help, seeing the diagram. Appreciate you sending it!

[JNXT 7707]

Just to close this out - DD40AX arrived today 

Although a bit nervous performing surgery on the brand-new beast, it went just fine and it's running great! Thanks guys.