EZ Command Control System

[bill collins]

I just converted to DCC using the Bachmann system. My new Bachmann switcher w/sound is working great. Problem is I tried my Bachmann Alaska DC, using the #10 as described in the directions, it jerked several times and then stopped. This locomotive has always worked fine on my DC layout. Any suggestions on want I may be doing wrong?

[keystone]

Bill........Just read your message. I'm not sure but the several jerks are a part of the DCC engine conversion. If itdid that and is correct, then press stop button to Exit and it should be programed.
Otherwise Some standard DC current engines on button ten do not have a motor that will adapt to the '10' button.    Am wondering if you solved the problem ? I have several std Dc engines that run on '10' fine.
Joe