H-0 E Z Command

[keystone]

 As usual I've misplaced the directions for the E Z Command unit. I'm fine with the use of 1 Controller. A few years back I purchased a second controller so 2 persons could run trains. I'm at a loss as to how to connect up the 2 units. The instructions I've printed, out state to connect the black interconnecting cable provide. I see a USB or similar port marked I/O but see no means to connect the 2 units into that port. I have the 2 wires that have the correct plug in to the I/O but the other ends are telephone (similar ) jacks. Trying to get this wired for a Christmas display so visitors can run a train. All help will be appreciated. Thanks.
Joe

[richg]

I do not have the EZ Command set but I would download the info from the Parts, Service & Information page that might show you something useful.

The below You Tube videos might show something.

http://tinyurl.com/aopdk3u

Rich

[Jerrys HO]

A few years back I purchased a second controller

If you purchased a second EZ Command it can not be used with another. If you purchased the Walk Around Companion then follow the video's.

Jerry

[keystone]

Thanks to you all, studying the Video and absorbing it.  Bringing back some memory as how, when I first purchased it. I have to go back and find the cables and see if I can find the remote plug in plate. I thought I had it all put away, seems I have more somewhere else.
  Part 3 of Video describes the remote plug in plate and wiring. Now if I can find the plate and wires ??
Joe