Lost

[Lucas1969]

Hello, yesterday during a short circuit i lost an engine, my dcc controler did not see it, i try to reprogram and nothing, i try to use it with analogue systeme and it's work but since the sort.. it refuse to work on dcc,

wath's wrong with this engine .......

Luc

[Jake]

The decoder is probably messed up. You *probably* need to get a new one. Those short circuits do a heck of a job on decoders. But before you buy a new one, take a decoder from another engine and see if it works. If it does it is the decoder and you can invest a few Euros in a new one. If it doesn't, then the problem is with your engine. Speaking of which, what type of engine was it? (Brand, Steam, Diesel, ect.)

[cmgn9712]

Probably just needs a resset. Do you know how to do this?

[Lucas1969]

It's an FT unit from bachmann with dcc on board and no i don't know how make an reset (i used bachmann ez command)

Luc

[WoundedBear]

The one B-Mann loco I have that is "DCC On Board" has it's decoder (44913) hard wired in. Swapping decoders may not be an easy job on this one of Luc's.

Luc....when on DCC, can you get the headlight to work? I take it she runs fine on DC? Unfortunately, the EZC from Bmann is not capable of resetting the decoders. Have you got any friends or a club nearby that have a more sophisticated DCC system? Perhaps they could attempt a reset for you.

BTW.....I still think it's crazy that the EZC cannot at least reset Bmann decoders.

If your loco is indeed hardwired, and not an 8 pin plug, then you may have to send her in for warranty.

Sid

[Lucas1969]

No, on DCC no light it's like the control see nothing on rail, but on DC all work.

Luc

[Beatle (TrainBrain)]

Is it MTH's K4? If it is, try Loco #3.