Richmond 4-4-0 tender to Spectrum 4-6-0

[Steam is King]

Hey Y'all,

Just like the title states. Will this combo work?

Thanks,

Manny

[rogertra]

Scan back looking for the gazillion posts on what to do if you want to swap tenders.  We discuss this all the time!

[NevinW]

I've done it.  This one works without any modifications at all.  Direct swap.  -  Nevin

[Pacific Northern]

I've done it.  This one works without any modifications at all.  Direct swap.  -  Nevin

Is this the low or high driver version? What is the roadname?

[rogertra]

I've done it.  This one works without any modifications at all.  Direct swap.  -  Nevin

Is this the low or high driver version? What is the roadname?

Doesn't matter!

[Pacific Northern]

I've done it.  This one works without any modifications at all.  Direct swap.  -  Nevin

Is this the low or high driver version? What is the roadname?

Doesn't matter!

The 4-6-0 with the high drivers come with three different tenders while the low driver version comes with the one size tender.

If I remember correctly at least on of the high driver versions is wired differently, of course moving the wiring harness will work then.

[rogertra]

I've done it.  This one works without any modifications at all.  Direct swap.  -  Nevin

Is this the low or high driver version? What is the roadname?

Doesn't matter!

The 4-6-0 with the high drivers come with three different tenders while the low driver version comes with the one size tender.

If I remember correctly at least on of the high driver versions is wired differently, of course moving the wiring harness will work then.

I stand corrected.  I have undecs of both types and while I had them appart it didn't seem to matter which tender I used.  I didn't realise there were three types of tender.  As you imply, it's not the tender it's the circuit board that's important.  As we've discussed here a zillion times.