E-Z command Control center

[donj42]

I have a E-Z Command control center that will not let me program my DCC equiped engine to a new address. I am following the programing instructions. Can anyone help?

[johnspat1]

I had the same problem when I purchased my E-Z Command.  I found that the instruction booklet was incorrect and when I downloaded the instructions from Bachmann there was a slight ,but significant difference. Try and print the following: www.bachmanntrains.com/home-usa/ezcommand.php?ezpage+1

[johnspat1]

The last part of the address should read:  ....ezpage=1

[srevac]

I had the same problem when I purchased my E-Z Command.  I found that the instruction booklet was incorrect and when I downloaded the instructions from Bachmann there was a slight ,but significant difference. Try and print the following: www.bachmanntrains.com/home-usa/ezcommand.php?ezpage+1

Great information.  I just unpack my E-Z Command controller and the same thing (as above) happened.  I too downloaded the corrected instructions and now everything is fine.  Great Forum with great members.  Thanks.