Acela

[full maxx]

I fried the lights of the dummy engine a few months back and would like to replace them...need the circuit board and wires and light board

[full maxx]

ok thanks but the board on mine has the leds made onto it...not bulbs with wire

[mlrr]

ok thanks but the board on mine has the leds made onto it...not bulbs with wire

Are you talking about the N scale version?

[full maxx]

no this is the ho board

[mlrr]

no this is the ho board

The bulbs should be wired to the board with wire leads.  The wire leads have to be de-soldered from the pc board and the replacements soldered to the same location.

I've seen all variants of the drives and pc boards but I haven't seen any of the pc boards where the leds are directly on them.  I'm assuming you mean that there's no easy way to remove the wires without soldering

[full maxx]

I have thrown away the board that was in the dummy engine but the bulbs were made onto the board without wires and they were square