DCC Controled switches

[jlester343]

I have two of the EZ Track DCC Crossover switches.  They respond to switch position 3.  I am using a Digitrax controler.  How can I reprogram them so each of the 4 switches had a different number?

[OldTimer]

The best place to look for answers to questions dealing with Digitrax products is the Digitrax knowledge base.  Look here:

http://tsd.digitrax.com//index.php?a=1492

These instructions are for the Zephyr, but if you have another system, you should be able to figure out the key presses.   Read your instructions.  Good Luck.
OldTimer

[RunningTrains]

I have two of the EZ Track DCC Crossover switches.  They respond to switch position 3.  I am using a Digitrax controler.  How can I reprogram them so each of the 4 switches had a different number?

You'll first need to check to see if you have the second run of DCC switches, the first run had decoders without a memory chip.
Bachmann will replace these if that is your problem.
I have a MRC Advance DCC system & using the ACCY feature, can number my switches by using a pen or something similar to hold the button down in the switch assembly - it will look like a nail hole but larger.

Assign a number to each switch - my Advance unit then assigns a number to it and I have to keep a written copy so I know the value of each it's also stored the the DCC.

You have to decide if #1 or #2 is straight thru or the turn.

Hope this helps.

John