E-Z Command #44902

[Trainutrico]

Hi,
I just bought an E-Z Command Control and seem to have a problem with the whistle function.
I press the F2 button and the whistle goes on BUT STAYS ON after releasing the button.  I have to press the F2 button a second time to make it stop.  With an MRC Prodigy DCC Control the whistle stops the moment I release the F2 button.  Is this normal?  Is my E-Z Control defective?   
I don't want to send it for repair and find out that it is supposed to act that way!!!
Thank you,

[ABC]

This is completely normal, you have to push the button a second time to turn off the whistle, bell, or horn. If you were to send it in, you would get the same controller back with a note that says nothing was wrong with it, and you'd be out about $10 for shipping. If you read the instruction manual first you would have found out that this is normal and your unit is not defective.

[Trainutrico]

Thanks for the info.  There was no instruction manual in the box, unless it was on the CD that came with the control.  I even went into uTube where they have 4 videos explaining the E-Z Command and they just mention the whistle briefly.

[Joe323]

The Instruction Manual is also here on the website as a PDF.