DCC in GE 45-Ton

[Arizona]

Anyone know of a web site with instructions on taking the 45 ton engine apart for DCC installation?

[calenelson]

I've had mine apart for RCS/Batt install.....don't remember it being too hard...be cautious of the steps, and grab rails...

..going back in my mind, I believe I just started taking screws out of the bottom, yep just ran out and looked it over...all the screws from bottom and there you go! 

I did go ahead and hard wire trucks and removed the plungers....that might not be your cup of tea...but it was pretty simple too! 

I removed all components from guts and tossed in a bin!

Good Luck
cale